Fit for 3/Y Engine Electronic Auxiliary Coolant Cooling Water Pump

Fit for Restore Your Thermal Management with a Direct Fit Coolant Pumpadvanced thermal management system relies on multiple electric coolant pumps to circulate fluid through the pack, drive unit, power electronics, and heat pump circuits . When one of these pumps fails, you may experience, reduced Supercharging speeds, poor cabin heat, or even power derating .Cause ExplanationContinuous duty in hot coolant Bearing and seal wear over time Debris or contaminated coolant Scores the impeller and housing, reducing flow Coolant leaks or air in system Pump runs dry, leading to overheating and seizure Improper refill without vacuum tool Trapped air causes cavitation, noise, and early failure Electrical overload or ingress Causes intermittent operation or failure Signs Your Coolant Pump Needs ReplacementThermal system warning messages on the touchscreenReduced vehicle performance or power deratingPoor cabin heating or defrost – especially in cold weatherCoolant circulation faults detected in Service ModeUnusual noise (whining, grinding) from the front compartment Vehicle CompatibilityProduct Features12V brushless electric pump – EV-grade design for continuous duty style electrical connector – Plug-and-play, no wiring modifications mounting points – Direct bolt-in replacement Restores proper coolant flow – drive unit from thermal damage Installation OverviewProfessional installation strongly recommendedSecurity preparation – Power down vehicle via touchscreen, disconnect lowDrain coolant – approximately 2-3 liters of spec blue coolant Install pump – Lubricate O-rings with coolant, press firmly into manifold Refill and bleed – Use Service Mode to run Coolant Fill & Bleed procedure. Vacuum fill is critical to aviod pockets that can the pump Maintenance TipsAlways use the correct spec blue coolant (G-48 type) Inspect hoses, O-rings, and the coolant manifold for leaks during replacement lightly lubricated O-rings on manifold ports aviod leaks Running the full Coolant Fill/Drain routine in Service Mode is essential – simply topping off can leave pockets What’s Included1 x Auxiliary Electric Coolant Pump (O-rings, coolant, and mounting hardware sold separately unless noted) Don’t let a failing coolant pump compromise your speed, or cabin comfort. Click “Add to Cart” to restore proper thermal management today.

• Fit for 【Restores & Drive Unit Cooling】 – Circulates coolant through, drive unit, power electronics, and heat pump circuits. Aviod thermal derating during Supercharging and maintains ideal operating temperature .
• 【Plug-and-Play Installation】 – style electrical connector and mounting points. No cutting, splicing, or software programming required – direct bolt-in replacement .
• 【Signs of Pump Failure】 – Coolant circulation faults, reduced vehicle performance, poor cabin heating/defrost, thermal system warnings, or unusual noise from front compartment .
• 【Professional Installation Recommended】 – Requires Service Mode access, coolant drain, and vacuum bleed procedure to aviod air pockets that can damage the pump .